No Data When Entering the Backend of Bitmain Antminer S19 Series

No Data When Entering the Backend of Bitmain Antminer S19 Series

The issue where the Bitmain Antminer S19 Series can access the backstage area but the interface is blank will be resolved by this guide.

Abnormal Performance

can access the backstage area, but the interface is data-empty.

Reasons and Solutions

  1. Either the setting is incorrect or the network is abnormal. The miner interface is hidden if, after turning on, the miner is unable to establish a connection to an external network. Network errors are typically recorded in the log. It is necessary to verify that the network cable is properly connected to the external network and that the IP settings or the mining pool’s settings are accurate.
  2. Protecting against high temperatures. The miner is automatically protected against high temperatures when it starts up due to the high temperature, and a notification of this protection can be found in the log. In general, it can be fixed by increasing ventilation, adding exhaust fans, adding water curtains, and adding hot and cold insulation to lower the ambient temperature.
  3. The PIC is abnormal; typically, the log will notify the user that the temperature is high, even though this is not the case. The temperature sensor circuit corrosion has been determined to be the primary cause of this issue and needs to be fixed, according to repeated analysis.

Please don’t hesitate to get in touch with us if you have any questions.

Leave a Comment

Your email address will not be published. Required fields are marked *

Scroll to Top